MaxScale 2.1 CLI
The command line interface as used by
maxadmin. The CLI router requires the
use of the
Two components are required to run the command line interface for maxadmin; a service and a listener. The listener may either use a Unix domain socket or an internet socket.
The default entries required are shown below.
[CLI] type=service router=cli # Unix Domain Socket [CLI Unix Listener] type=listener service=CLI protocol=maxscaled socket=default # Internet Socket [CLI Inet Listener] type=listener service=CLI protocol=maxscaled address=localhost port=6603
In the example above, two listeners have been specified; one that listens on the
default Unix domain socket and one that listens on the default port. In the
latter case, if the
address= entry is removed, connections are allowed from
any machine on your network.
In the former case, if the value of
socket is changed and in the latter case,
if the value of
port is changed, maxadmin must be invoked with the
-P options, respectively.
If Unix domain sockets are used, the connection is secure, but maxadmin can only be used on the same host where MariaDB MaxScale runs. If internet sockets are used, the connection is inherently insecure but maxadmin can be used from another host than the one where MariaDB MaxScale runs.
Note that the latter approach is deprecated and will be removed in a future version of MariaDB MaxScale.