HintRouter

HintRouter

HintRouter was introduced in 2.2 and is still beta.

Overview

The HintRouter module is a simple router intended to operate in conjunction with the NamedServerFilter. The router looks at the hints embedded in a packet buffer and attempts to route the packet according to the hint. The user can also set a default action to be taken when a query has no hints or when the hints could not be applied.

If a packet has multiple hints attached, the router will read them in order and attempt routing. Any successful routing ends the process and any further hints are ignored for the packet.

Configuration

The HintRouter is a rather simple router and only accepts a few configuration settings.

default_action=<master|slave|named|all>

This setting defines what happens when a query has no routing hint or applying the routing hint(s) fails. If also the default action fails, the routing will end in error and the session closes. The different values are:

Value Description
master Route to the master server.
slave Route to any single slave server.
named Route to a named server. The name is given in the default_server-setting.
all Default value. Route to all connected servers.

Note that setting default action to anything other than all means that session variable write commands are by default not routed to all backends.

default_server=<server-name>

Defines the default backend name if default_action=named. <server-name> must be a valid backend name.

max_slaves=<limit>

<limit> should be an integer, -1 by default. Defines how many backend slave servers a session should attempt to connect to. Having less slaves defined in the services and/or less successful connections during session creation is not an error. The router will attempt to distribute slaves evenly between sessions by assigning them in a round robin fashion. The session will always try to connect to a master regardless of this setting, although not finding one is not an error.

Negative values activate default mode, in which case this value is set to the number of backends in the service - 1, so that the sessions are connected to all slaves.

If the hints or the default_action point to a named server, this setting is probably best left to default to ensure that the specific server is connected to at session creation. The router will not attempt to connect to additional servers after session creation.

Examples

A minimal configuration doesn't require any parameters as all settings have reasonable defaults.

[Routing-Service]
type=service
router=hintrouter
servers=slave1,slave2,slave3

If packets should be routed to the master server by default and only a few connections are required, the configuration might be as follows.

[Routing-Service]
type=service
router=hintrouter
servers=MyMaster, slave1,slave2,slave3,slave4,slave5,slave6,slave7
default_action=master
max_slaves=2

Comments

Comments loading...
Content reproduced on this site is the property of its respective owners, and this content is not reviewed in advance by MariaDB. The views, information and opinions expressed by this content do not necessarily represent those of MariaDB or any other party.